تسجيل الدخول إنشاء حساب جديد

voltage source أمثلة على

"voltage source" معنى  
أمثلةجوال إصدار
  • Miller theorem implies that an impedance element is supplied by two arbitrary (not necessarily dependent) voltage sources that are connected in series through the common ground.
    تقتضي مبرهنة ميلر أن العنصر المُقاوِم يتم تزويده بمصدرين عشوائيين للجهد (ليسا بالضرورة تابعَين) متصلين بسلسلةٍ خلال أرض عادية.
  • It asserts that a floating impedance element, supplied by two voltage sources connected in series, may be split into two grounded elements with corresponding impedances.
    وهي تؤكد أن العنصر المقاوم للطفو عندما يتم تزويده بمصدري جهدٍ متصلين في سلسلة، يمكن عندئذ شطر العنصر إلى عنصرين مؤرّضين لكلٍ منهما مقاومة متناظرة.
  • For experiments, he initially used voltaic piles, but later used a thermocouple as this provided a more stable voltage source in terms of internal resistance and constant potential difference.
    وعند عمله المختبري استخدم في البداية بطارية فولطية، ولكنه استخدم بعدها مزدوجة حرارية كي يتمكن من الحصول على مصدر جهد أكثر استقرارا من حيث المقاومة الداخلية وفرق الجهد المستمر.
  • Performing a source transformation consists of using Ohm's law to take an existing voltage source in series with a resistance, and replacing it with a current source in parallel with the same resistance, or vice versa.
    لتحويل المصدر يجب استخدام قانون أوم لجعل مصدر جهد موصل على التوالي مع المقاومة , واستبداله بمصدر تيار على التوازي مع نفس المقاومة .
  • Thévenin's theorem allows a non-ideal current source model to be converted to a non-ideal voltage source model and Norton's theorem allows a non-ideal voltage source model to be converted to a non-ideal current source model.
    حيث تسمح مبرهنة ثيفينين لمصدر التيار غير المثالي أن يتحول إلى مصدر جهد غير مثالي كما تسمح مبرهنة نورتون لمصدر الجهد غير المثالي بأن يتول إلى مصدر تيار غير مثالي.
  • Thévenin's theorem allows a non-ideal current source model to be converted to a non-ideal voltage source model and Norton's theorem allows a non-ideal voltage source model to be converted to a non-ideal current source model.
    حيث تسمح مبرهنة ثيفينين لمصدر التيار غير المثالي أن يتحول إلى مصدر جهد غير مثالي كما تسمح مبرهنة نورتون لمصدر الجهد غير المثالي بأن يتول إلى مصدر تيار غير مثالي.
  • If there is a voltage source in series with an impedance, it is possible to find the value of the equivalent current source in parallel with the impedance by dividing the value of the voltage source by the value of the impedance.
    إذا كان هناك مصدر جهد موصل على التوالي مع المعاوقة , فإنه من الممكن إيجاد القيمة المكافئة لمصدر التيار الموصل على التوازي مع المعاوقة بقسمة قيمة مصدر الجهد على قيمة المعاوقة .
  • If there is a voltage source in series with an impedance, it is possible to find the value of the equivalent current source in parallel with the impedance by dividing the value of the voltage source by the value of the impedance.
    إذا كان هناك مصدر جهد موصل على التوالي مع المعاوقة , فإنه من الممكن إيجاد القيمة المكافئة لمصدر التيار الموصل على التوازي مع المعاوقة بقسمة قيمة مصدر الجهد على قيمة المعاوقة .
  • Both models are equally valid, but the voltage source model is more applicable to when the internal resistance is low (that is, much lower than the load impedance) and the current source model is more applicable when the internal resistance is high (compared to the load).
    كلا النموذجين صحيح على حد سواء , لكن مصدر الجهد يكون قابل للتطبيق أكثر عندما تكون المقاومة الداخلية منخفضة (أقل بكثير من معاوقة الحمل) ويكون مصدر التيار قابل للتطبيق أكثر عندما تكون المقاومة الداخلية عالية (بالمقارنة مع الحمل ) .
  • The equations Norton gives for his filter correspond to a singly terminated Butterworth filter, that is, one driven by an ideal voltage source with no impedance, whereas the form more usually given in texts is for the doubly terminated filter with resistors at both ends, making it hard to recognise the design for what it is.
    تتوافق المعادلات التي قدمها نورتون عن مُرشِّحه مع مُرشِّح باترورث أحادي الطرف، وهذا يعني أن هذا المُرشِّح مزود بمصدر جهد كهربائي مثالي بلا معاوقة، بينما الشكل الذي يظهر عادةً في النصوص يكون للمُرشِّح مزدوج الطرف المزود بمقاومات عند طرفي النهاية، مما يجعل إدراك ماهية عمل التصميم أمرًا صعبًا.